MODEL PROFILE
Signal or code
Error codes and display signals
The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.
No matching signal for this model.
Model and error-code facts may be shown in the language of the original source.
Official PDF manual
Jump to manual pages
Open the official PDF at pages that document signals for this model.
MODEL OVERVIEW
About this model: Frigidaire FFCS0562AW
FFCS0562AW is Frigidaire's compact convertible chest freezer with a digital high-temperature alert and a documented E2 sensor fault.
Identify the compact DualChill cabinet and its actual controls
The white FFCS0562AW is a 5.1-cubic-foot chest cabinet, not a stand-up refrigerator with a freezer compartment. Its exact specification gives a width of 23 5/8 inches and a depth of 22 1/8 inches, useful when planning floor space and lid access. Two baskets and an interior LED help organize items; the owner's guide limits the slide-aside basket to 11 pounds. Frigidaire calls this model garage-ready and lists a digital display, control lock and high-temperature alarm. The exact sheet also lists ENERGY STAR certification and annual energy of 196 kWh, an estimate rather than a promise for every garage climate. The product's DualChill feature allows the entire cabinet to serve as either a freezer or a refrigerator. Verify FFCS0562AW on the rating label before applying its display instructions to another small chest freezer.
Prepare a safe change between freezer and refrigerator modes
Location and mode matter more here than on a fixed-temperature chest freezer. The exact product page describes a freezer ambient range of 0 to 110°F, while the owner warns against installing it below 38°F in refrigerator mode. Leave 7.87 inches at both sides and the back for air movement; a tight alcove can distort the expected cool-down. After starting, operate the cabinet closed for at least four hours before adding unfrozen food. The freezer settings span 10 to -11°F, whereas refrigerator settings span 32 to 50°F. To change modes, hold Freeze Boost and Temp together for five seconds. Empty the cabinet first, dry frost or condensation and allow six to 24 hours for the new temperature to stabilize before reloading. If freezing fresh food, the guide caps one batch at three pounds per cubic foot and advises distributing packages rather than piling them in one corner.
Interpret HI and E2 without confusing them with ordinary settings
Read the display literally. HI means the sensed cabinet temperature exceeds the chosen setting. Pressing any button clears the alert, but clearing it does not by itself cool the food or establish why the temperature rose. Check whether the lid shut fully, whether warm groceries were just loaded, and whether the cabinet is still stabilizing after a mode change. E2 is different: the guide labels it temperature-sensor failure and tells the owner to contact a service provider. Do not treat E2 as a request to adjust the thermostat or to replace a guessed part. Fb is also different: it marks Freeze Boost, an optional setting available only in freezer mode, not a fault. Holding Temp for three seconds changes Fahrenheit and Celsius; holding Freeze Boost for three seconds locks or unlocks the controls. A locked panel blinks twice if a setting change is attempted.
Plan defrosting and a power interruption
This model requires manual defrost. The guide calls for defrosting when frost reaches roughly one-quarter to one-half inch. Unplug the cabinet before starting, move the food, and use a plastic scraper; metal tools can damage the liner. The floor and outside drain plugs provide a route for meltwater, so place a shallow pan beneath the outlet and restore the plugs afterward. A power interruption is a separate situation from E2. The guide says a closed lid can keep frozen food frozen for at least 36 hours, and discourages unnecessary opening. Once supply returns, previous settings resume except Freeze Boost, which must be selected again if wanted. Those statements concern freezer use; do not transfer the 36-hour frozen-food guidance to refrigerator-mode perishables. Look at actual food condition and temperature after an extended outage.
Investigate long runs and warm food with the model's own guide
If the compressor seems to run too long, do not assume the HI alert or E2 fault is always responsible. The troubleshooting table points first to hot surroundings, frequent or lengthy lid opening, a lid that is not fully shut, a dirty or damaged gasket, recent disconnection and active Freeze Boost. Warm food also makes the motor run longer until the set temperature is reached. A warm interior may reflect a setting that is too high, repeated opening or a recent restart; the manual allows time for the cabinet to recover. Confirm the current REF or FRZ mode, check the set temperature and compare it with the food being stored. If HI comes back after the practical checks, or E2 is shown, record the exact display and contact Frigidaire service. The official manual's fault explanation is a guide to the next action, not a substitute for a measured temperature.
Verified model details
Exact 5.1-cu-ft white model with two baskets, LED light and garage-ready specification.
Source for this detailHI warns that cabinet temperature is above the setting; E2 identifies a sensor fault needing service.
Source for this detail · Source page: 7The same cabinet changes between freezer and refrigerator operation, with different ambient limits.
Source for this detail · Source page: 9
This description summarizes the linked source documents; check each cited source for your exact model and region.
Manufacturer source
Open official source
Frigidaire 5.1 Cu. Ft. Convertible Garage Ready Chest Freezer — FFCS0562AW
Open official sourceIf there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.