MODEL PROFILE
Signal or code
Error codes and display signals
The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.
No matching signal for this model.
Model and error-code facts may be shown in the language of the original source.
Official PDF manual
Jump to manual pages
Open the official PDF at pages that document signals for this model.
MODEL OVERVIEW
About this model: GE GTW335ASNWW
GE GTW335ASNWW is a 4.2-cu.-ft. top-load washer with a stainless-steel basket. On equipped models, its Consumer Help Indicator describes a blinking Spin light for an unbalanced load and a blinking Fill light when water does not enter as expected. GE advises leaving the lid open after a wash so moisture can evaporate and checking the inlet hoses for wear or leaks.
Exact washer configuration
GTW335ASNWW has a published 4.2-cubic-foot capacity and a stainless-steel basket. That figure is useful when comparing cabinet models, but it does not specify the mass of every kind of laundry the washer can move effectively. GE's owner guide asks for articles to be placed loosely around the basket. Before copying a cycle suggestion from another GTW washer, identify the controls actually fitted to this one; the shared guide shows options that may appear only on some members of the family.
Water level and sensing
A useful distinction for GTW335ASNWW is between expected load sensing and a fill warning. GE says some models briefly operate the cold-water valve, pause and then continue when a cycle starts or resumes after the lid closes. On models using Auto water level, opening the lid can delay filling. The manual also explains that a washer may use less visible water than an older machine. If the Fill light repeatedly gives the documented two-blink pattern, that is not merely a quiet sensing pause; check the cited indicator entry.
Load and detergent
Place pieces loosely around the perimeter so water and detergent can reach them and the load can shift during wash action. The guide recommends high-efficiency detergent in a dose suited to load and soil. Too much product can cause excessive suds, while an uneven mass of clothing may later trigger a blinking Spin light. Those are separate concerns even when both leave a load unsatisfactory.
Controls fitted to this SKU
GTW335ASNWW shares an owner guide with washers that show extra controls in the illustrations. Look at the labels physically present on this model before following a setting sequence from that guide. The exact product record establishes the basket and capacity, but it does not confirm Cold Plus or Stain PreTreat for this SKU. If a button named in another GTW model description is absent, select among the installed programs. A missing option is not itself one of GE's blinking-light fault patterns.
Reading the lights
The Consumer Help Indicator table shared with GTW335ASNWW says that, on equipped models, a blinking Spin light can accompany an unbalanced load while the washer tries to redistribute it. A Fill light blinking twice means the control did not sense water accumulating during fill; three blinks refer to water left for 15 minutes with the lid open. Those are different causes despite using the same light. Count the blinks and observe the lid before following the corresponding owner-level steps.
Lid and routine care
GE recommends leaving the lid of GTW335ASNWW open for a while after washing so moisture can evaporate. Inspect its inlet hoses periodically for wear or leaks as the care guidance describes. During a cycle, however, a lid left open with water in the basket can lead to an automatic drain after 15 minutes.
Steps tied to the signal
For a two-blink Fill condition on GTW335ASNWW, GE's owner-level step is to make sure both household supply valves are open and water is available; the control may then complete a timed lockout and pump phase. Three Fill blinks point instead to water left with the lid open, so closing it is the relevant first action. If the issue returns, the guide directs owners to GE service. These directions depend on the exact blink count and are more reliable than assuming every flashing Fill light means a blocked valve.
Verified model details
4.2-cu.-ft. top-load washer with a stainless-steel basket.
Source for this detailOn equipped models, blinking Spin or Fill lights can flag balance or water-fill conditions.
Source for this detail · Source page: 13GE advises leaving the lid open after a wash so moisture can evaporate and checking the inlet hoses for wear or leaks.
Source for this detail · Source page: 17
This description summarizes the linked source documents; check each cited source for your exact model and region.
Manufacturer source
Open official source
GE Appliances GTW335ASNWW Owner Center and manual
Open official sourceIf there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.