WT6105CW

Configuration and exact-model context

WT6105CW is a 4.1 cu. ft. agitator top-loader with a Deep Fill choice for bulky items. Its manual explains fault and status states through panel lights, so the pattern must be recorded precisely. An Extra Rinse light blinking on this model is not the same observation as Extra Rinse together with Cold blinking. That difference matters more during troubleshooting than simply reporting that the washer stopped mid-cycle.

Physical fit and installation reading

The WT6105CW owner material lists a 27-inch width and 57 1/4-inch height with the lid open. It uses an agitator in a 4.1-cubic-foot tub, so do not identify it solely from the similar WT6100CW number or a photo of the control panel. In a utility room with cabinets above the washer, check the raised lid against the lowest obstruction. The panel's Extra Rinse and other lights also need to remain visible: this model communicates some diagnostic states through light combinations rather than a two-letter display. The dimensions and indicator table are separate sections of the same manual.

How to read the documented signals

The manual assigns Extra Rinse LED Blinks a specific meaning: The load cannot be balanced for spinning. Its first documented response is to add items to a very small load. By comparison, Warm LED Blinks means water is entering too slowly or not at all. LG initially directs the owner to open the water taps fully. The two displays point to different checks even if the cycle stops in a similar way.

For Cold LED Blinks, LG writes that the washer is not draining properly; the first listed step is to clear or straighten the drain hose. The Extra Rinse and Cold LEDs Blink entry instead reports: An object may be trapped between the pulsator and the tub. Its initial instruction is to switch the washer off and on, then run a spin-only cycle. The distinction is in the complete displayed signal, rather than a broad symptom description.

Another entry, Rinse+Spin LED Blinks, is explained this way: The washer is automatically draining after a paused cycle. The associated first action is to allow the drain operation to finish. Tub Clean LED Blinks has a separate explanation: The washer is asking for a Tub Clean cycle. For that indication LG starts with an instruction to run the tub clean cycle as described in the manual. The signals concern separate conditions, even though both can interrupt an ordinary cycle.

The LG manual also explains Control Lock LED ON: The control panel is locked. It first instructs the owner to turn off control lock using the control panel instructions for this model. For Door Lock and Control Lock LEDs Blink, the manual says the door or lid is not closed securely; it first instructs the owner to close the door or lid firmly and remove trapped laundry. They identify different conditions even if both appear during the same general phase of use. The full display string or light pattern remains the most useful detail to record.