MODEL PROFILE
Signal or code
Error codes and display signals
The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.
No matching signal for this model.
Model and error-code facts may be shown in the language of the original source.
Official PDF manual
Jump to manual pages
Open the official PDF at pages that document signals for this model.
MODEL OVERVIEW
About this model: Midea MLC31N4AWW
MLC31N4AWW combines ventless washing and drying in one front-load body, with five owner-manual codes and a visible source-dimension discrepancy.
Confirm the exact combo and its dimensions
MLC31N4AWW is Midea Canada's white, 3.1-cubic-foot, front-loading washer-dryer combo. One cabinet handles both parts of a laundry routine, which can be valuable in a small home that lacks space for separate machines. The exact product listing calls it ventless, gives a 161-pound weight and specifies a digital display. It lists the cabinet as 23.5 inches wide, 23.5 deep and 33.5 high. The linked owner PDF, however, prints 595 by 640 by 850 millimetres in its technical table; the depth there is about 25.2 inches. The two sources therefore disagree about depth. Allow room for the actual cabinet, water connections and door swing, and verify measurements before building a tight recess. The PDF cover visibly prints MLC31N4AWW, and its error-code page repeats the exact SKU, anchoring this guide to the right appliance.
Set up water, drain and power
The product specifies 120 V at 60 Hz, a maximum spin speed of 1400 rpm and pump drainage. The owner guide forbids an extension cord or adapter and calls for a properly grounded supply. It also warns against outdoor locations, dripping water and carpet; the supporting surface must be hard and steady. Two water hoses are required, while a drain-hose guide and inlet screens are included. Before connecting, the instructions say to flush the cold water line to remove particles and check the rubber washers in the hose fittings. Keep hoses free of kinks as the machine moves into its final position. A ventless design removes the need for a dryer exhaust duct, but it does not remove the need for water supply, safe drainage, electricity and access to the front door. Those practical connections govern the usable location more than the space-saving label alone.
Choose washing and drying controls
The exact model page lists 16 cycles, including Normal/Cotton, Heavy Duty, Bulky/Large, Wool, Delicates, Quick Wash, Tub Clean, Timed Dry and Auto Dry. The owner description distinguishes a Wash and Dry selection that runs without interruption from a Dry selection, and describes Quick Wash for small, lightly soiled loads. A user can therefore decide whether garments should be washed and dried together or whether a previously washed load needs only drying. The digital panel displays remaining time and cycle status; it also offers a child lock and a delayed start. In the guide, holding Soil Level and Dryness together for three seconds sets the child lock, while the delay spans zero to 24 hours. If adding an item after starting, pause and wait for the door to unlock; the instructions allow up to 30 seconds. Do not pull the locked door. The product says Steam Function No even though the shared manual discusses Steam, so this article does not promise that option on MLC31N4AWW.
Maintain the door and pump safely
The stainless-steel inner tub resists routine wear, but the wash and drain paths still need attention. The owner guide calls for a Washer Clean or Tub Clean cycle at least monthly to limit soil and detergent buildup. The drain-pump filter catches fibres, coins and other small objects, and the instructions say to clean it periodically. If emptying or spinning becomes slow, inspect the accessible drain hose first; a blocked filter is another documented cause. The warning beside the filter is important: water can be hot, so never remove the pump cover during a cycle. Wait until the program is over and the machine is empty before following the filter-cleaning steps. After moving the appliance, recheck its leveling feet and hose route; both can affect vibration and drainage without implying an electronic fault. These checks are distinct from dismantling the pump or control electronics.
Read the five actual error entries
The rendered error table on PDF page 24 records five entries for this exact model. E30 means the door is not closed correctly; look for trapped clothing, close it and restart as directed. E10 concerns water entering during washing; the manual names low pressure, kinked hoses and a blocked inlet-valve filter. E21 means draining took too long, pointing to the drain hose or pump filter. E12 indicates overflow. The table says restart, but first ensure there is no active water escape and make the area safe; repeated overflow warrants service. EXX is an 'other' category, not a specific part diagnosis; the guide says try again and call the service line if trouble persists. Record the whole display, the chosen wash or dry operation and the point at which it stopped. These five codes are grounded in the linked MLC31N4AWW owner PDF, not a generic Midea code list.
Verified model details
3.1-cu-ft front-load combo with 16 programs
Source for this detailProduct and PDF dimensions differ in depth
Source for this detailPump-filter, door-lock and wash/dry care guidance
Source for this detailE30, E10, E21, E12 and EXX on PDF page 24
Source for this detail
This description summarizes the linked source documents; check each cited source for your exact model and region.
Manufacturer source
Open official source
3.1 Cu. Ft. Ventless Washer Dryer Combo Main | Midea CA
Open official sourceIf there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.